THE FREQUENCY Page 2

  Go to Frequency opening page

.. 

"This wave is infinitely variable, it seems. you have to chase it with careful adjustments."  HANS

Diagram 

 

Op amp is: Motorola MC1741CP1. 

Pin 1. and pin 5. each go to separate outer lugs of potentiometer A.(Centre lug goes to V- .)  Pin 2. goes to outer lug of pot B { The remaining lugs of pot B are tied together, and to Vground.(neutral).  The case of pot B is also Vground.  Pin 2 also goes to comon point of 1 Megohm 1/4 Watt 20% carbon res, and neg side of 0.22 mF mylar or epoxy capacitor.  The res. and cap. are in parallel.  Pin 3. is the wide-open input from antenna coil ( I used two glass diodes back to back for input protection. Si.).  Pin 4. goes to V-, at the centre lug of the pot A .  Pin 5. see first line.  Pin 6. is the output, direct-coupled to scope input.  Pin 6. also connects to the second comon point of the parallel 1 Meg res. and 0.22 mF cap. (whose other end connects to pin 2.)  Pin 7. goes to V+.  Pin 8. is no connection, open float. Parts beyond chip, i resistor, one capacitor, two pots, two diodes.  Notes: Both cases of the pots are connected to Vground.  Watch this when working with pot A, as its centre lug is V-, NOT Vground.  All system ground is Vground.  Input and output are mini-shielded inside box to their jacks.  Pot A is 20Kohms. Pot B 500 Ohms.

THE OMEGA DEVICE

WARNING! 

Remember that all this is just imagination, 

and meant to be FUN! 

BUT IT COULD EXPLODE OR KILL YOU! 

The writing on the ugly drawing is repeated here;  The median diameter of the circular part is 6 feet.  The material should be rare-earths magnet, if it will conduct current at a nominal resistance of less than one Ohm along its entire length, not just the power-connecting points "C and C1".   The diameter of the material rather than the circular part, is 2 inches.  Where the outer diameter touches the base, is where the coil winding begins.  Go all the way around, and end at the similar junction on the other base; (lucky there's a gap of 2 inches.)  The windings should be able to carry an immense "current". Wire the unit according to the configuration shown on zero-point web-site, under Colerp.  I know nothing about the danger or functionality of these things.  I just think it would be very interesting, and maybe effective --who knows?  I think Coler's system uses more than one module, and has plates of some kind.  The Germans powered a flying-saucer with Coler's system, right?  Adapt as you see fit.  Again, you are at your own risk.  BEWARE!!  Consult with zero-point first.  Coming up next, the activator,  following which is the passive hyper-space window. 

NOTES FROM EMAIL.......... NOTES FROM EMAIL 2

NOTES FROM EMAIL 3 ...... NOTES FROM EMAIL 3

 ARCHIVES: GREEK ALPHABET AND ANCIENT DEVICES

OMEGA CROP CIRCLE